Before I Beeswax A Recently Sanded Body - ProjectGuitar.com
2005年8月2日 · I intend to keep the natural finish using beeswax. However, once the sanding is done, whats the best way to prep the guitar ready for waxing? I've seen on here in so...
Walk me through sanding and finishing with Tru Oil
2015年11月15日 · The method of putting on a fair bit of tru oil and sanding while wet is to get the wood dust to mix with the tru oil to fill the pores. If you have already sealed it with a sealer and pore filler there is no point wet sanding. And yes for a body I would build up probably a lot more than 6 thin coats.
How to prep bodies for painting? - OffsetGuitars.com
2015年5月22日 · My understanding of prepping is that the body should be thoroughly sanded to 240 grit, after which 2 coats of sanding sealer are applied to the body. A grain filling product is applied, let to dry, then the body is level sanded again.
Sanding a Guitar Body Prior to Painting - Guitar Kit World
2021年5月21日 · In the following article, we're going to cover some of the basics of guitar sanding. While it may seem fairly obvious, in essence, correct preparation will make or break the quality of your guitar kit's finish so it makes sense to take the time to do the job properly.
Refinishing an oiled and waxed guitar, how to remove the old finish
2024年9月3日 · Yes, some of the surface wax will wick into the blotting paper or tea towel as it melts, but it also chases some of it deeper into the wood grain than it already was, so when you realise that there is still a waxy coating on the wood and try and sand through it to the wood you won't get to the wood until you've sanded your body down to the ...
Questions about painting a guitar body - OffsetGuitars.com
2010年8月2日 · I would shoot a full can on the body, let it dry overnight & sand with 600 grit. Wet sanding with a drop or two of dish soap will keep the sandpaper from clogging. Use a block on the flat parts to get it flat.
Guitar Finishing 101: The Highlighted Grain & Stain Finish
2024年2月29日 · Be sure to hold the body of the guitar up to the light and observe the finish from a variety of angles as lighter scratches will only be visible from certain angles depending on the source of the light. Keep sanding until you are satisfied with the surface of the guitar and finish up by using the fine grade steel wool. Step 11: Polishing
How do I hand sand my guitar body properly before I apply paint?
2021年1月16日 · An essential guide to getting your guitar body ready to finish. We focus on the process of sanding, and include which sandpaper and sanding blocks you need.
Staining a guitar body - OffsetGuitars.com
2012年1月3日 · But for staining swamp ash, I`d start with sealing the body with shellac, buy shellac flakes and mix them yourself. Lots of the pre-mixed have wax in them. The Have you got some grain filler? You could also tint the grain fill if you`re using a lighter color, to accent the grain. I`ve bought both shellac flakes and grain filler from StewMac.
Wet sanding - The Acoustic Guitar Forum
2011年10月29日 · You only need a little bit of water, and keep a towel handy to wipe down the surface you're sanding to check it. You can use a rubber block (waterproof), or some people use a felt or cork block. I like solid hard felt blocks best, very light weight and softer than rubber or cork, but they are hard to find.
- 某些结果已被删除