Which cure time should be used for the Hilti HIT-RE 500 V3?
Two cure times are listed since HIT-RE 500 V3 has relatively long cure times. The initial cure time “t cure ini” is the time at which 25% of the working load could be applied. The full cure time “t cure full” is time at which 100% of the working load could be applied.
RE-500 Curing time - Hilti USA
Concrete cure time is different than cure time of the adhesive. Cure times for HIT-RE 500 V3, dependent on the base material temperature, can be found in Figure 9 on page 181 of the Hilti Anchor Fastening Technical Guide. Two cure times are listed since HIT-RE 500 V3 …
Replacement for HILTI HIT-RE 500 V3
I am working on a DSA project that has received plan check comments back recently. One of the comments pertains to our general notes section on adhesive anchors, in which they commented on our specification of Hilti HIT-RE 500-V3 with Phasing out, suggest replacing with a currently available product. Can you confirm...
Hilti Hit 500 v3 pull out test values - Hilti HIT-RE 500 V3, p...
Hilti HIT-RE 500 V3, pull out, stainless steel anchor. 0 Likes 1 Reply. 1 Reply. Posted by PARIS STANTON ...
Using 500 V3 volume to fill around anchor bolts. - Hilti
Using 500 V3 with a 1 1/4" all thread rod and a 1 1/2" hole using a hammer drilled going 42" deep about how many tubes would be required per hole? Hilti HIT-RE 500 V3, I can’t seem to find the answer online or in the product data.
Hilti HIT-RE 500 v3 - once frozen
Hilti adhesive anchors have storage and transportation, installation, and in-service temperature requirements. The storage and transportation temperature requirements for HIT-RE 500 V3 are 41 - 77 °F. Unfortunately, Hilti does not have testing for temperatures outside the requirements, and does not recommend using adhesive after being frozen.
RE 500 V3 Allowable Temperature - tensilte bond strength, epox...
Per ESR-3814 for HIT-RE 500 V3, the maximum long term temperature is 110 deg. Fahrenheit. The use of the adhesive at a higher temperature is outside the scope of Hilti’s testing. The decision to utilize HIT-RE 500 V3 in an environment with a higher long term temperature would up to the discretion of the Engineer of Record for the project ...
Embedment Depth for #9 Rebar in 6000 psi Concrete Using Hilti ...
I am working on a project that involves post-installed #9 rebar in 6000 psi concrete with Hilti HIT-RE 500 V3 epoxy. I reviewed Table 31 in the ESR-3814 report, which provides embedment depths for 2500 psi and 4000 psi concrete, but I couldn’t find specific recommendations for 6000 psi concrete. Could you confirm i...
Since HIT-RE 500 V3 is epoxy, is it better than HY-200 in vibr...
Please click here to access the guide from the Hilti UK website. Specifically, please review the summary on Page 14, Specifically, please review the summary on Page 14, Section 2.4.6.
HIT RE500 V3 Pull Out Test - anchor, calculations - Hilti USA
I would like to know the pull out test requirements for HIT RE500 V3 using bar M16, hammered drilled and embedded 150mm into C30/37 uncracked concrete. What is the tensile and shear strength for the test?