2000年7月24日 · 1. Install the new module first. 2. Connect the WDS and ID the vehicle as normal. 3. From the Toolbox icon, select and highlight "Module Programming" and press check mark from the toolbox menu. 4. Select and highlight "Programmable Module Installation" and then highlight module that was replaced and press check mark. 5.
Ford® Programmable Module Installation | Quick Tip - YouTube
2023年1月15日 · When you replace computer modules on a Ford® vehicle, like ECM or TCM, you'll need to use the Programmable Module Installation function where the information on the old module is copied...
2004年1月20日 · The Ford Module Programming application is intended to be used by vehicle repair shops to program modules on Ford, Lincoln and Mercury vehicles. In addition, PATS functions such as Keycode
Module Programming and Reprogramming Procedures – Ford
2016年5月5日 · Programmable Module Installation (PMI) When replacing a module, this function ensures the correct software/calibration and configuration data are loaded onto the new module. This is required regardless of whether or not the original module is available.
Programmable Module Installation (PMI) PMI is a scan tool process which configures settings in a new module. Data used for the PMI process is automatically downloaded from the original module
Ford Taurus Service Manual: Module Configuration - Electrical ...
Programmable Module Installation (PMI) is a scan tool process which configures settings in a new module. Data used for the PMI process is automatically downloaded from the original module and stored when a scan tool session is started.
2014年4月24日 · Programmable Module Installation (PMI) UNTIL PERFORMING STEP 8. DO NOT TURN procedure must be performed. Use the THE KEY ON WHEN WDS IS INITIALLY WDS session opened at Step 1. CONNECTED TO THE DLC. b. If DTC P0602/P0605/P1639 is not present, 3. Connect WDS to vehicle. then verify Programmable Parameters are properly set such as tire size, axle ...
Ford Kuga: Programmable Module Installation - Module …
In order to program, select the "Install programmable module" submenu in the "Module programming" menu tool box and then follow the instructions. 8. The following modules must be programmed after replacement:
2016年10月14日 · Choose programmable module installation. Before installing the module, clear DTCs and configure an auxiliary power supply to keep the decoder power supply connected.
To carry out PMI , refer to Programmable Module Installation (PMI) in this section. NOTE: It is important that the scan tool identifies the vehicle and obtains configuration data prior to removing any modules. The new module must be able to communicate with …
- 某些结果已被删除