Rubicon locker sensor replacement - Jeep Enthusiast Forums
2016年6月7日 · I believe the sensor on my front locker was pulled and improperly reinstalled by a previous owner and needs to be repositioned behind the pressure plate. The locker works fine but the indicator light on the dash flashes instead of displaying solid when the locker engages.
e-locker reinstallation issues | JKOwners Forum
2008年7月9日 · It definitely sounds like the plunger is pushing against the side gear plate and causing the locker to lock. It needs to be over the plate and is pulled out by the plate when the locker engages to tell the system it is locked. This is a common mistake. Here's a quick diagram I did that shows the correct position of the plunger:
Rubicon Gear Install Locker Tip - JKOwners Forum
2009年12月7日 · The plunger can also be bent when installing the diff. This stops it pulling out when the locker is engaged, and it exerts enough force on the plate to prevent the side gear engaging. This is how the sensor plunger should look.
Replacement for the factory Rubicon E-locker - Jeep Wrangler Forum
2023年3月4日 · I've made a couple phone calls to some local shops and everyone has recommended swapping out the factory E-locker with an ARB air locker. I have many a question in regards to this issue and not looking forward to the pricetag to switch to the ARB system. 1. Which locker is more prone to failure? Factory E-locker or ARB air locker?
Locker Indicator Switch Plunger Question - Rubicon Owners …
2010年4月4日 · my locker lights on the dash flash but both lockers appear to work correctly. so i have been reading my fsm and posts online. from what i am gathering i can replace the locker indicator switch on the rear from the outside and on the front will need to pull out the carrier.
Mopar Axle Locker Sensor Reviews - Quadratec
2020年7月22日 · Crown Automotive Axle Locker Actuator and Sensor Connector for 07-18 Jeep Wrangler & Wrangler Unlimited JK Rubicon
- 评论数: 1
Replacement for the factory Rubicon E-locker - Jeep Wrangler …
2023年3月6日 · There’s a locker sensor (plunge switch) that can be reinstalled incorrectly during a regear. Maybe that’s your issue. If the locker proving switch is not installed correctly then it will jam up the locker, and that is a common mistake when regrearing. Make sure the switch is not binding on the locker plate. The plate should move freely by hand.
Rubicon locker repair experience - Jeep Wrangler Forum
2017年5月27日 · In my opinion, the JK e Locker is a great design as 12V is reliable and easy to repair compared to airlines. The lockers in my rig have been there for 10+ years and 162K miles. If they need a couple shims to remove slack that often I'm ok with it.
Rubi locker switch for Eaton E lockers | Rubicon Owners Forum
2015年5月26日 · I had previously done the locker bypass and have independent front / rear locker control, So I have 2 switches to use... Instead of activating the locker pump with a flip of the switch, it will activate the E locker ( I hope) But then I need to get the "plunger" to send a signal...
OEM Rubicon Locker Study - JKOwners Forum
2013年2月9日 · That could be the cause of locker ratcheting. Installing a shim to make up the difference has at least temporarily fixed it in some cases. Here is a look at how the Rubicon e-locker works.