How to properly daisy chain network switches? - Super User
2019年9月9日 · I'll then put a network switch in the 1st floor utility box, so the internet can be sent via Cat3 cable to "Bedroom A" and "Bedroom B". In bedrooms "A" and "B" I need to split the signal again to connect to multiple devices. Now my question: I'd like all three network switches to be of the good and cheap variety. Something like the $15 TP-Link 5.
networking - Switch caused problems to the network - Super User
2016年4月18日 · There must be a network congestion or cable looping issue on your work. To find this, remove all network cables from the switch, and put one by one. Then find on each computer, is there any weird behavior, slowness etc. Also check with a spare switch, the same issue happens in a network, there must be problem in system's side NIC also.
Crossover cable or straight through between multiple hubs/switches
2018年9月12日 · Most modern hardware – Ethernet switches and computer Ethernet interfaces – implements Auto-MDIX, automatically choosing the correct mode for each physical connection. (This is now a required part of Gigabit Ethernet, but also very common among 100 Mbps ports as …
networking - Multiple switches - how does it work? - Super User
2014年12月1日 · I was reading about networking hardware some time ago and came across an explanation on how network switches work - basically, it said that a switch keeps an internal database of what MAC address is connected to each port, and when it receives a packet, it will look up the destination MAC in its database and forward the packet to the correct port.
Will multiple switches slow transfer speed - Super User
2013年1月18日 · For a full length Ethernet frame of 1542 bytes and 100Base-T, three store-and-forward switches would add latency of about 369 microseconds, whereas three cut-through switches would add latency of about 3.7 microseconds.
How can I select a good UPS for network hardware?
Stack Exchange Network. Stack Exchange network consists of 183 Q&A communities including Stack Overflow, the largest, most trusted online community for developers to learn, share their knowledge, and build their careers. Visit Stack Exchange
What happens if an unmanaged ethernet switch is looped …
"Dumb" Switches You have just created a loop in the network topology. In a moment or two, your network, (all the segments off this dumb switch) will probably stop working as the dumb switch sends the first broadcast packet out one of those two switch ports, receives the packet on the other, and then sends it out the other, etc. Packet storm ...
networking - Why do switches say 10/100/1000? - Super User
2018年2月13日 · Stack Exchange Network. Stack Exchange network consists of 183 Q&A communities including Stack Overflow, the largest, most trusted online community for developers to learn, share their knowledge, and build their careers. Visit Stack Exchange
Mesh Network Topology with 'Prosumer' Equipment - Super User
2020年6月25日 · The "mesh network" will actually make it harder for the switches than a simple star topology, because it creates loops, and the switches must work harder to avoid those loops (which would flood your network with packets going in …
Why doesn't it matter which ports I use on a switch?
On some switches, there is an advantage to having devices that exchange a lot of traffic connected to the same switching module as that reduces backplane congestion. Most modern Gigabit switches, managed and unmanaged, having 24 ports or fewer support full, non-blocking traffic on all ports.